Advertising Feather Flags And Banners

Advertising Feather Flags, Advertising Feather Flags And Banners

Advertising Feather Flags, Advertising Feather Flags And Banners

custom flags   trade show table covers   Custom Tents   Beach Flags

Advertising Feather Flags And Banners   Advertising Feather Flags And Banners


Color, color defects in dyeing finished many of them are caused by the fabric does not meet the requirements, Advertising Feather Flags And Banners such as warp and weft wrong, the reed, and wearing the wrong, will appear in varying degrees by the file to the color in the dyeing and finishing, Backpack Banner Advertising  affect the quality of finished products, especially in the dye where Lamine blue cloth, soil forest blue cloth and curing blue cloth and other more significant. Warp breaks in weaving a long time were not connected, resulting in the warp in the fabric shortage or interruption, breaking through at the darker staining, Advertising Feather Flags And Banners and can also cause the hole. Drag yarn if not timely pruning, remain in the fabric dyeing process (pad) that cause drag the white yarn printed or light-colored drag yarn India. Weaving factory warp waxing, such as the outer wax, cloth on the wax content of 0.7% to 1.0%, making it easy to refuse to dye spot. Weaving factory in the wash in addition to oil stains on the fabric, remove the net or stains spread, can also cause stains and India. Swooper Feather Flags Wholesale

Fabric weaving defect missing by the weft, thin weft, thin to get spider web, etc., cause the color defect, thin fabric, such as with the above weaving flaws, could easily lead in the singeing singeing hole even ignite fabric. The fabric cloth roll wrinkled, singeing singeing streak will finally result in the staining of the Flower. Polyester blended amorphous uneven cause dyed fabric skirt wrinkled ". Fabric width less than the final product will not meet the standard, even in the tenter barely pull enough zonal shrinkage is difficult to meet the standards, sometimes because the deadlift increase will be broken Brad.

From the fiber material, spinning, weaving the various processes into a process to produce a flaw, will ultimately affect the quality of the dyeing and finishing products. Fabric weaving factory finishing workshop, Advertising Feather Flags And Banners after inspection and repair, can improve the fabric pass rate, but in  and dyeing processing by repair flaws will remain in the  and dyeing cloth, exposed, and should therefore be to strengthen the management of various processes, as far as possible reduce errors and reduce the fabric flaws to a minimum, in order to obtain good quality textiles.

Pre-treatment in the first chapter Discount Swooper Flags


Without dyeing and finishing fabrics are collectively referred to as the original cloth or fabric, of which only a small amount of supply market, the vast majority of the original cloth will take in the  and dyeing mill for further processing into bleached fabrics, Custom Outdoor Banner Flags color cloth or fabric for consumer use. Often contain a considerable amount of impurities in fabric, including cotton fibers with biological and impurities, weaving warp yarn stiffening material, chemical fiber on oil and oil buildup in the textile process. If you do not remove these impurities, dirt, will not only affect the fabric color, feel, and fabric moisture absorption, so that the fabric color uneven, the colors are not bright, but also affect the color fastness. Advertising Feather Flags And Banners

The purpose is to make pre-treatment of fabric damage small, blank fabric to remove various impurities on the fabric, white, soft and good wetting properties dyer semifinished products. The pre-treatment is the preparation of textile dyeing and finishing processes, also known as bleaching, for the pre-treatment of cotton and cotton fabrics prepared, singeing, desizing, scouring, bleaching, mercerizing processes, but of different varieties of fabric, Cheap Teardrop Flags pre-treatment requirements are inconsistent, the regional plant production conditions are not the same, thus the fabric in the former processing workshop experience processing order (process) and process conditions are often different.


Deal with water and additives in the first section before

First, pre-treatment of water

Feather Flags Feather Flags Wholesale Custom Feather Flags

Feather Flag & Pole & Spike & Base: As low as $49.00 to $59.00 !
Custom 3x5 Flags: As low as $6.00 to $13.50 !
Hand Flags: As low as $0.50 to $1.50 !
Car Flags: As low as $1.00 to $3.00 !
  All pricing based on quantity desired.
Unlimited Colors & No Set-up Fee's!

Minimum Order: 1

 custom printed flags
  • Color:  Any colors are available, Unlimited Colors & No Set-up Fee's!

  • Logo:  Any logos are available

  • Flags Material:   Knitted material / 100% Polyester / Nylon / Cotton / Satin and etc

  • Flagpole Material:  Aluminium alloy / Fiberglass / Wooden / Plastic

  • Normal Flag Size:   2'x3', 3'x5', 4'x6', 5'x8' and can be customized.
  • Hand Flag Size:  5"x8",  8"x12", 12"x18" and can be customized.
  • Car Flag Size:  8"x12", 12"x18" and can be customized.
  • Feather Flag/Teardrop Flag size:
  • S, pole total height is 8.5ft, after setting up, it is about 7ft.  (flag size: about  5.8'x1.3' ) 
    M, pole total height is 11 ft, after setting up, it is about 9.2ft. (flag size: about 7.9'x2.0' )
    L, pole total height is 15.1ft, after setting up, it is about 13ft.  (flag size: about 11.2'x2.3' )
    XL, pole total height is 18.4ft, after setting up, it is about 16ft. (flag size: about 13.5'x2.6' )

  • Delivery Time:    small order – 1 to 2 days, big order – 10 to 15 days

  • Shipping Time:  1 to 2 days to North America, Europe.
  •                                           2 to 3 days to Australia, New Zealand.
  •                                           3 to 5 days to other countries.