Custom Printed Outdoor Flags



Custom Printed Outdoor Flags

Custom Printed Outdoor Flags


custom flags   trade show table covers   Custom Tents   Beach Flags

Custom Printed Outdoor Flags   Custom Printed Outdoor Flags

 

This equipment is usually sealed, Custom Printed Outdoor Flags with a high voltage performance, it is known as the high temperature high pressure dyeing machine can be used for dyeing of synthetic fiber and its blended yarn can be used for the dyeing of cotton yarn, and thus wide adaptability, yarn dyed is becoming increasingly important. Promotional Yard Flags

(D) cheese dyeing machine bobbin dyeing machine for a pressurized closed equipment, the composition of the dye tank, storage sump, creel, and circulating pump. Dyeing yarn cartridges in cheese shelves, Custom Printed Outdoor Flags the dye out of the hole from the creel to the storage sump pump pressure after the yarn layer, staining trough. Intervals dye for reverse circulation. Cheese dyeing, the yarn winding bobbins must be appropriate and good, not too tight and too loose. Figure 2-8 shows the schematic of cheese dyeing machine.

Figure 2-7 high temperature and pressure yarn dyeing machine

Of 1 – Slot 2 – sleeve cage – nozzle Garden House Flags Wholesale

4 – sleeve cage 5 – circulation pump – Motor

Figure 2-8 cheese dyeing machine

1 – high pressure dye vat – fibrous scaffold 3 – into small prototype 4 – four-way valve 5 – circulating pump

6 – expansion tank – plus trough 8 – compressed air 9 – Custom Printed Outdoor Flags auxiliary slot 10 into the water pipes

11 – condensate – Steam 13 – gas discharge port

Five other dyeing machines Outdoor Decorative Flags

(A) silk overflow dyeing machine

The silk fabric is delicate and should be low tension, less friction loose dyeing equipment. Practice hanging slot, star-shaped rack, jigger, rope dyeing machine, the cage-type dyeing machines, Custom Printed Outdoor Flags overflow dyeing machines, jet dyeing machine can be used as a silk fabric dip equipment, but these devices are not for each type of silk fabrics or of each dye are applicable. Dyeing equipment should be based on the raw material of the fabric, the fabric structure and dye selection.

Silk Dyeing machine structure shown in Figure 2-9.

Figure 2-9 silk overflow dyeing machine Buy Feather Flags

1 – into the silk window 2 – conduction silk roll – Custom Printed Outdoor Flags guide silk piping – heat exchanger 5 – relief valve

6 – Pumping control valve – the main circulating pump – Custom Printed Outdoor Flags flow control valve 9 – feed regulator valve 10 – discharge valve

11 – plus drums 12 – drain valve 13 – silk roll 14 – filter

The aircraft by the dye tank guided silk roll, plus drums, heat exchangers, filters, and out of the silk frame, and a variety of piping and other components. Fabrics move smoothly, any part of the fabric in the dye tank can and dye contact with or immersed in the dye the fabric into the dye slot, driven by the flow of each staining tube equipped with two independent guide silk piping separated silk horses, to ensure The fabric is mobile in the best condition. Dye slot is the same, so the stain evenly.

    Aircraft to enhance roll a position adjustable large diameter guide silk roll the roll to avoid large-diameter guide silk fabric guide silk roller skid, thereby reducing the possibility of the fabric guide silk roller surface abrasions, In addition the guide silk made of drum-shaped roller, which is the middle of large diameter, both ends of the diameter, Swooper Flags Manufacturer fabric slitting, while avoiding its deviation, so well into the overflow pipe. Guide silk roll away from the surface close to the minimum distance of 15 mm. Guide silk roller to extract the fabric weight (the weight of the fabric weight and fabric absorb dye) greatly reduced, at the same time the tension of the fabric suffered also greatly reduced, the dyeing of the silk. Custom Printed Outdoor Flags

    Overflow pipe cross-section is oval, which can help the fabric to run as much as possible within the overflow pipe, to avoid turbulence. Compared with the ordinary circular section overflow pipe, oval overflow pipe to reduce the tangle of fabric, but also to avoid the shortcomings of easy staining of dead ends at the overflow pipe of rectangular cross section.


Feather Flag & Pole & Spike & Base: As low as $49.00 to $59.00 !
Custom 3x5 Flags: As low as $6.00 to $13.50 !
Hand Flags: As low as $0.50 to $1.50 !
Car Flags: As low as $1.00 to $3.00 !
  All pricing based on quantity desired.
 
Unlimited Colors & No Set-up Fee's!

Minimum Order: 1

 custom printed flags
 
  • Color:  Any colors are available, Unlimited Colors & No Set-up Fee's!

  • Logo:  Any logos are available

  • Flags Material:   Knitted material / 100% Polyester / Nylon / Cotton / Satin and etc

  • Flagpole Material:  Aluminium alloy / Fiberglass / Wooden / Plastic

  • Normal Flag Size:   2'x3', 3'x5', 4'x6', 5'x8' and can be customized.
  • Hand Flag Size:  5"x8",  8"x12", 12"x18" and can be customized.
  • Car Flag Size:  8"x12", 12"x18" and can be customized.
  • Feather Flag/Teardrop Flag size:
  • S, pole total height is 8.5ft, after setting up, it is about 7ft.  (flag size: about  5.8'x1.3' ) 
    M, pole total height is 11 ft, after setting up, it is about 9.2ft. (flag size: about 7.9'x2.0' )
    L, pole total height is 15.1ft, after setting up, it is about 13ft.  (flag size: about 11.2'x2.3' )
    XL, pole total height is 18.4ft, after setting up, it is about 16ft. (flag size: about 13.5'x2.6' )


  • Delivery Time:    small order – 1 to 2 days, big order – 10 to 15 days

  • Shipping Time:  1 to 2 days to North America, Europe.
  •                                           2 to 3 days to Australia, New Zealand.
  •                                           3 to 5 days to other countries.

Tags: