Discount Decorative House Flags

Discount Decorative House Flags


custom flags   trade show table covers   Custom Tents   Beach Flags

Discount Decorative House Flags   Discount Decorative House Flags

 

Cook to practice the quality of the yarn to the capillary effect as the inspection standards, general requirements for the capillary effect of the average above the 10cm/3Omin. For low temperature dyeing warp, Discount Decorative House Flags the gross effect of more than 13.5 ~ 15cm/30min. After scouring wash yarn pH 7-8, the breaking strength of not less than the original strength of yarn. Scouring the yarn should be white, calcium spots, raw spots, alkali spots, rust, wrinkle-free yarn mess yarn.

(3) yarn scouring instance:

clear boiled yarn: Yuan Gong dyed yarn using sulfide yuan (green) stained denim to curing Blue Ransha, reduce pigmentation, red muscle, neither alkali cooking stained shade, but the fastness somewhat less. Clear boiled yarn without any chemicals, you can put in 100 water immersed 1.5 ~ 2h. Discount Decorative House Flags

lye boiled yarn: pure cotton with caustic soda (100%) 12 ~ 14g / L, Discount Decorative House Flags scouring 3 ~ 4h at 130 ° C, and then rinse drain pan yarn pH value should be the 7 to 8 65 / 35 polyester-cotton blended yarn with caustic soda 3 ~ 4g / L, and cook for 3h at 100 ° C, drain flushing 1h pan. 50/50 Victoria Cotton blended with caustic soda to 7g / L at 84 ° C scouring 3 ~ 4h, drain flushing. Can also be used soda ash scouring, scouring liquid in addition to soda ash, also joined the industrial soap powder and detergents, 80 ° C and cook 3 ~~ 4h. Customized Monogram Garden Flags

2 bleaching yarn cotton yarn chlorine bleach-based. Chlorine bleach can be poured bleach method, continuous chain method, crawler law bleach. Poured bleach yarn piled up in the pouring bleach inside the drift fluid pump out from the yarn above the shower, and cyclic, is the intermittent production. Discount Decorative House Flags The chain method is hank sets strung together a chain-like, chain yarn continuously in sequence through the drift of liquid pool pool pickling tank pool dechlorinated pool → → washing pool demolition chain dehydration with white. This method is very high yield. Tracked method, also known as the rejection of the drift method, the yarn is divided into half a pack a set of triangular rods of stainless steel, Discount Decorative Garden Flags rod end is equipped with the pinion when the pinion tooth pattern board into the car body produced before and after rotation, cotton yarn and thus bleach evenly, will not cause the chain yarn knot macula. The whole car by the track shoe drive into the horizontal line moves forward, the device including bleaching the pool, take the air pools, ponds, acid pools, ponds, and dechlorinated pool, washed with white pool, the pool can automatically cycle feeding high degree of mechanization . Colored Feather Flags

Bleached yarn and cotton cloth chlorine bleaching process is similar. Discount Decorative House Flags Concentration of available chlorine: pouring bleach solution with chlorine concentrations of 0.8 to 1.2g / L, continuous bleaching is 1.5 to 2g / L Bleach liquor ratio 1:6 to 8: pouring bleach, continuous bleaching 1:35 40. Some yarn will take after rinsing the soap boiling, available white appearance and smooth soft feel and luster.

Bleached yarn quality should be white, uniform, no stains, no spots, no residual chlorine, the yarn surface pH of 7 to 8, the yarn breaking strength of not less than 96% of the bleach before. Sports Team Feather Flags

(3) the purpose and effect, and the cotton of yarn mercerized yarn mercerized mercerizing conditions are basically the same. Mercerized uniform or not directly affect the quality of staining. Discount Decorative House Flags

(1) yarn mercerized equipment: yarn mercerizing equipment arms hank mercerizing machine and rotary hank mercerizing machine, the former small footprint, which yields.

 Figure l-12 for the arms hank mercerizing machine.

Figure l-12-style arms hank mercerizing machine schematic

1 – Richard Creel 2 – sets of yarn roller – roll – water disk 5 – alkali disk

6 – pulley 7 – Tension adjustment wheel – Electrical – formwork

Automatic arms type hank mercerizing machine mercerizing operation, first prepared in advance and cooled to a certain temperature, the mercerizing solution flourished in the disk of the alkali, will be pre-prepared skein set in the roller, start the mercerizing machine, roller distraction to the required distance from the When alkali disk rises, the yarn that is, immersed in the mercerizing solution, rotation in the roller, steering interchangeable. Roller tension in this process, Discount Decorative House Flags first relax a little later to restore the original tension. Roll while the pressure required to put pressure on a roller. After clockwise 1 min, 1min after reverse the roll to stop pressure on alkali disk that decline. Custom Made Wind Flags When the water tray to move to the bottom of the roller, spray pipe began to spray warm water roll has returned to put pressure. After a certain period of time the spray rinse, the water pipe to stop the spray, roll stop to put pressure on the roller stops rotating at the same time remove the water tray, roller simply that close to each other. Hank is removed from the roller, and for pickling.


Feather Flag & Pole & Spike & Base: As low as $49.00 to $59.00 !
Custom 3x5 Flags: As low as $6.00 to $13.50 !
Hand Flags: As low as $0.50 to $1.50 !
Car Flags: As low as $1.00 to $3.00 !
  All pricing based on quantity desired.
 
Unlimited Colors & No Set-up Fee's!

Minimum Order: 1

 custom printed flags
 
  • Color:  Any colors are available, Unlimited Colors & No Set-up Fee's!

  • Logo:  Any logos are available

  • Flags Material:   Knitted material / 100% Polyester / Nylon / Cotton / Satin and etc

  • Flagpole Material:  Aluminium alloy / Fiberglass / Wooden / Plastic

  • Normal Flag Size:   2'x3', 3'x5', 4'x6', 5'x8' and can be customized.
  • Hand Flag Size:  5"x8",  8"x12", 12"x18" and can be customized.
  • Car Flag Size:  8"x12", 12"x18" and can be customized.
  • Feather Flag/Teardrop Flag size:
  • S, pole total height is 8.5ft, after setting up, it is about 7ft.  (flag size: about  5.8'x1.3' ) 
    M, pole total height is 11 ft, after setting up, it is about 9.2ft. (flag size: about 7.9'x2.0' )
    L, pole total height is 15.1ft, after setting up, it is about 13ft.  (flag size: about 11.2'x2.3' )
    XL, pole total height is 18.4ft, after setting up, it is about 16ft. (flag size: about 13.5'x2.6' )


  • Delivery Time:    small order – 1 to 2 days, big order – 10 to 15 days

  • Shipping Time:  1 to 2 days to North America, Europe.
  •                                           2 to 3 days to Australia, New Zealand.
  •                                           3 to 5 days to other countries.

Tags: